Shandong Fengtu IOT Technology Co., Ltd
Sales Manager:Ms. Emily Wang
Cel,Whatsapp,Wechat:+86 15898932201
Email:info@fengtutec.com
Add:No. 155 Optoelectronic Industry Accelerator, Gaoxin District, Weifang, Shandong, China
Sales Manager:Ms. Emily Wang
Cel,Whatsapp,Wechat:+86 15898932201
Email:info@fengtutec.com
Add:No. 155 Optoelectronic Industry Accelerator, Gaoxin District, Weifang, Shandong, China
Model:JC-1.8B
Brand:fengtu
1. Product principle
The high-frequency microwave pulse emitted by the guided wave radar propagates along the detection component (steel cable or steel rod), encounters the measured medium, causes reflection due to a sudden change in the dielectric constant, and part of the pulse energy is reflected back. The time interval between the transmitted pulse and the reflected pulse is proportional to the distance of the measured medium.
2. Technical parameters
Applicable medium: liquid, solid powder
Application: liquid and solid powder measurement, complex process conditions
Explosion-proof certification: Exia IIC T6 Ga/Exd ia IIC T6 Gb
Measuring range: liquid 0~20 meters, solid powder 0~10 meters
Frequency: 500MHz-1.8GHz
Antenna: Single Cable Antenna
Measurement accuracy: ±10mm
Process temperature: (-40~250)℃
Process pressure: (-0.1 ~ 4) MPa
Signal output: (4~20)mA/HART
On-site display: four-digit LCD programmable
Power supply: two-wire system (DC24V)/four-wire system (DC24V/AC220V)
Housing: Aluminum/Plastic
3. Product Features
The antenna is small in size and easy to install; non-contact radar, no wear and pollution.
Almost unaffected by corrosion and foam; almost unaffected by changes in water vapor, temperature and pressure in the atmosphere.
Severe dusty environment has little effect on the work of high frequency level meter.
Shorter wavelengths provide better reflection from inclined solid surfaces.
The beam angle is small and the energy is concentrated, which enhances the echo capability and helps avoid interference objects.
The measurement blind area is smaller, and it will also achieve good results for the measurement of small tanks.
High signal-to-noise ratio for better performance even in fluctuating conditions.
High frequency, the best choice for measuring solid and low dielectric constant media.
A wind speed and direction sensor is a device used to measure and record wind speed and direction information, which is widely used in meteorology, aviation, marine, agriculture and other fields. In these fields, accurate wind speed and direction information is of great significance for forecasting...
Most of the new energy research and development work is actually carried out in a relatively open environment, especially for wind and solar energy research and development, often due to the installation of the environment is very open caused by some important devices are easily affected by changes...
Road surface condition data is one of the most important parameters of concern for traffic safety, apart from visibility. Whether there is water on the road surface. Snow, ice and other road conditions are one of the safety hazards alerted to. FT-LM2 non-contact road condition detector uses remote s...
Piezoelectric rain sensors use the impact measurement principle to measure the weight of individual raindrops and thus calculate the amount of rainfall. The raindrops are influenced by the weight of the raindrops and air resistance during their fall. When they reach the ground, the velocity is const...