Shandong Fengtu IOT Technology Co., Ltd
Sales Manager:Ms. Emily Wang
Cel,Whatsapp,Wechat:+86 15898932201
Email:info@fengtutec.com
Add:No. 155 Optoelectronic Industry Accelerator, Gaoxin District, Weifang, Shandong, China

Sales Manager:Ms. Emily Wang
Cel,Whatsapp,Wechat:+86 15898932201
Email:info@fengtutec.com
Add:No. 155 Optoelectronic Industry Accelerator, Gaoxin District, Weifang, Shandong, China
time:2024-12-26 10:51:20 source:Weather Station viewed:650 time

1.Principle of water level detection products
water level detection is used to detect the level of moveable substances and can be used to accurately determine the level of water in tanks, ponds, rivers or any other body of water.The radar level antenna emits narrow microwave pulses, which are transmitted downward through the antenna. After the microwave contacts the surface of the measured medium, it is reflected back and is received again by the antenna system. The signal is transmitted to the electronic circuit part and automatically converted into a level signal (because the microwave propagates extremely fast, the electromagnetic wave reaches the target and is reflected back to the receiver. The time taken is almost instantaneous).
2.Water level detection technical parameters
Application: temperature-resistant, pressure-resistant, slightly corrosive liquids
Measuring range: 30 meters
Process connection: thread, flange
Medium temperature: -40~250℃
Process pressure: -0.1~4.0MPa
Accuracy: ±3mm
Protection level: IP67
Frequency range: 26GHz
Explosion-proof level: ExiaⅡC T6 Ga/Exd ia IIC T6 Gb
Signal output: 4...20mA/HART (two wires/four wires) RS485/Mod bus
3.Features of water level detection products
The antenna is small in size and easy to install; the non-contact radar has no wear and pollution.
Almost unaffected by corrosion and foam; almost unaffected by water vapor, temperature and pressure changes in the atmosphere.
Serious dust environment has little impact on the operation of high-frequency level meters.
The wavelength is shorter and reflects better on tilted solid surfaces.
The beam angle is small and the energy is concentrated, which enhances the echo capability and helps avoid interference.
The measurement blind area is smaller, and good results can be achieved for small tank measurements.
High signal-to-noise ratio for better performance even under fluctuating conditions.
High frequency, it is the best choice for measuring solids and low dielectric constant media.
Air quality sensors are used to detect airborne pollutants such as the familiar PM10 and PM2.5 particulate matter. These particles can affect our health, especially PM2.5 because it is very fine and can penetrate deep into the lungs. The Air Quality Index (AQI) uses the concentration of these partic...
With data collectors, sensors, wireless transmission devices, mounting brackets and software platforms, the wireless automatic weather station is an integrated IoT weather monitoring system that not only automatically collects and records weather environment and soil moisture conditions, but also tr...
Soil moisture monitoring is crucial for agricultural production, water resource management, flood warning and drought assessment. Soil moisture research has been carried out at home and abroad.For example, in the mid-to-high altitude areas of Switzerland, the SOMOMOUNT network has been established t...
Ultrasonic Wind Speed Direction Sensor is a wind - measuring instrument produced by Fengtu....