Shandong Fengtu IOT Technology Co., Ltd
Sales Manager:Ms. Emily Wang
Cel,Whatsapp,Wechat:+86 15898932201
Email:info@fengtutec.com
Add:No. 155 Optoelectronic Industry Accelerator, Gaoxin District, Weifang, Shandong, China

Sales Manager:Ms. Emily Wang
Cel,Whatsapp,Wechat:+86 15898932201
Email:info@fengtutec.com
Add:No. 155 Optoelectronic Industry Accelerator, Gaoxin District, Weifang, Shandong, China
time:2024-12-25 11:41:01 source:Weather Station viewed:633 time

1.Industrial sensor product principle
industrial sensor is a kind of equipment in industrial automation, which can detect the change of quantity and convert it into an output signal, including pressure sensor, infrared sensor, smoke sensor, optical sensor and so on.The radar level antenna emits narrow microwave pulses, which are transmitted downward through the antenna. After the microwave contacts the surface of the measured medium, it is reflected back and is received again by the antenna system. The signal is transmitted to the electronic circuit part and automatically converted into a level signal (because the microwave propagates extremely fast, the electromagnetic wave reaches the target and is reflected back to the receiver. The time taken is almost instantaneous).
2. Industrial sensor technical parameters
Application: temperature-resistant, pressure-resistant, slightly corrosive liquids
Measuring range: 30 meters
Process connection: thread, flange
Medium temperature: -40~250℃
Process pressure: -0.1~4.0MPa
Accuracy: ±3mm
Protection level: IP67
Frequency range: 26GHz
Explosion-proof level: ExiaⅡC T6 Ga/Exd ia IIC T6 Gb
Signal output: 4...20mA/HART (two wires/four wires) RS485/Mod bus
3. Industrial sensor product features
The antenna is small in size and easy to install; the non-contact radar has no wear and pollution.
Almost unaffected by corrosion and foam; almost unaffected by water vapor, temperature and pressure changes in the atmosphere.
Serious dust environment has little impact on the operation of high-frequency level meters.
The wavelength is shorter and reflects better on tilted solid surfaces.
The beam angle is small and the energy is concentrated, which enhances the echo capability and helps avoid interference.
The measurement blind area is smaller, and good results can be achieved for small tank measurements.
High signal-to-noise ratio for better performance even under fluctuating conditions.
High frequency, it is the best choice for measuring solids and low dielectric constant media.
Float-type and pressure-type sensors are prone to being affected by water flow scouring, sediment deposition, water quality corrosion, and floating debris impacts, leading to reduced measurement accuracy, equipment damage, and difficulty in stable operation under severe weather conditions. However,...
water quality sensor is used to measure common water treatment parameters, such as dissolved oxygen, conductivity, turbidity, pH, temperature, ammonium, nitrate, chloride, etc....
Marine meteorological monitoring instruments, also known as ship weather instruments, are specifically designed for the marine environment. They integrate six parameters—temperature, humidity, wind speed, wind direction, air pressure, and rainfall—into a single unit, enabling 24-hour continu...
IV curve testing is an important means to evaluate the electrical performance of photovoltaic modules or arrays. By measuring the current of photovoltaic devices at different voltages, the current-voltage (IV) curve is plotted, and key parameters such as short-circuit current, open-circuit voltage,...